Operating Guide

  • TURN

    Browse pages in a group;
    move through menus or
    change an editing value.

  • PRESS

    Open the highlighted item,
    select an option or confirm an
    edit.

  • HOLD 1 SEC

    Open the main menu, then
    release. Turn to a group and
    press to enter.

  • HOLD 5 SEC

    Keep holding past the menu
    to switch Dark Mode on or
    off.

01 SCREENS & READINGS

ENGINE RPM, speed, load, throttle, coolant, MAF (g/s), air
mass (kg/h), intake-air temperature, oil temperature, boost,
estimated torque/power and gear, where available.
ELECTRICAL Battery voltage, highest/lowest session voltage,
battery-health indication and oxygen-sensor voltages.
FUEL Fuel consumption, fuel flow and fuel-rail pressure, where
supported.
RACE Two editable dashboards: MAIN and SCREEN 2. Turn to
swap between them. These are live displays, not race timers.
DRIVE REPORT Session peaks for coolant/IAT, speed/RPM
and boost; minimum voltage, new fault count and a summary
rating. Paired values are stacked.
TRIP Driving time + distance, then average + top speed.
Collects automatically once valid speed data arrives with the
engine running. Trip/report totals reset on gauge restart.
DPF For supported diesel data: soot, exhaust temperature,
regeneration status/history, differential pressure and Codes.
Enable in DISPLAY > DPF MONITOR.
CODES While parked, select READ CODES. Turn to browse
results; CLEAR erases stored OBD engine faults and does not
repair their cause. After a read, CLEAR is highlighted: turn
before pressing if you only want to browse.
On DPF Codes, turn past the results/actions to reach the other
DPF pages. Ordinary Codes has EXIT.

02 BUILD YOUR RACE VIEW

SETTINGS > RACE > MAIN or SCREEN 2
Choose MAIN ARC, TOP VALUE, BOTTOM VALUE or
BOTTOM ARC. Turn to a parameter and press to save it. Each
dashboard keeps its own four choices. Unsupported readings
can show --.
Start there: DISPLAY > STARTUP PAGES > RACE > MAIN or
SCREEN 2. Press to save, then restart. A regular startup choice
replaces it. If RACE is hidden, startup falls back to RPM until
RACE is shown again.

03 SETTINGS

Hold 1 second for the menu, enter SETTINGS, then choose a
section below.
GENERAL > VEHICLE INFO VIN, ECU, engine, protocol and
odometer if supported. Turn through three pages; press to
return.
RPM SET RPM changes the scale (5,000-20,000). SET RED
LINE / SET ORANGE LINE edit low/high band limits. SHIFTER
LIGHTS sets the trigger and enables/disables it. These settings
do not change the engine limiter.
THEMES Turn to preview a style; press to apply/save. BACK
keeps the previously saved theme.

04 DISPLAY SETTINGS

BRIGHTNESS EDIT > turn (10-100%) > SAVE sets night
dimming. Its THEME editor chooses an alternate night style.
Select DISABLE there to use percentage dimming; a night
theme runs at full brightness. Hold 5 seconds to try Dark Mode
after saving.
SCREENS Choose a group; press a page to show/hide it, or use
the group hide/show option. At least one page must remain in a
visible group. Unavailable optional pages are omitted.
STARTUP PAGES Choose an available page and press to
save. Includes both Race dashboards; takes effect on restart.
UNITS RPM: centre number shows RPM or speed. SPEED:
MPH/KM/H. TEMP: C/F. BOOST: PSI/BAR. Press the desired
choice to save.
WARNINGS Enable/disable cold engine, warm engine, hot
coolant, low battery, alternator and check-engine alerts. Edit
temperature/RPM/voltage thresholds where offered;
check-engine is ECU controlled. TEST WARNINGS previews all
alerts. Cold MIN TEMP and ENGINE WARM share one
temperature setting.
COOLANT TEMP Set L/H for the green display band. Warning
thresholds are adjusted separately under WARNINGS.
COLD CAR REDLINE Adjust MIN or ENABLE/DISABLE the
visual cold-engine aid. Saving MIN enables it; it is not an ECU
limiter.
DPF MONITOR Press OFF or ON. The saved choice stays
yellow; white shows knob focus. Use EXIT to leave.
SCREEN ANGLE EDIT > turn > SAVE: 0, 90, 180 or 270
degrees. BACK returns to Display.

Use menus while parked

Missing values or -- mean usable data is not available yet. Oil/gear and other optional readings depend on the car.
Power, torque, fuel and health/rating indications can be estimates.